Jump to content

Reinforce HDMI


Recommended Posts

The simple answer is to buy a not shitty camera that has SDI or full hdmi's. However there are just so many good cheap options out there with this one downfall, micro HDMI. So my question is would there be a way to take apart a camera say XT3, Sigma FP or whatever camera it is, and reinforce the micro HDMI port so it doesn't break so easily. 

I have taken apart cameras before but I am not familiar enough with electronics to know if something like this would be possible without destroying the electronic board. 

 

Link to post
Share on other sites
2 hours ago, IronFilm said:

Practically speaking, the simplest/cheapest/fastest/best solution is just buy a camera rig which has a locking pin for the HDMI connector. That's the first thing I bought when I got my BMPCC.

of course although people report micro hdmi's breaking even with these precautions. I've heard this type of cable plus the locking pins could be a winner.

tCrBm8Y.jpg

This takes the stress off of the micro HDMI port even more than just an adapter where the port is still receiver direct stress. Its still worrisome. 

 

Link to post
Share on other sites

Or, instead of a cage with a locking pin, just go with a less expensive, delicate HDMI gimbal cable with a right-angle micro-HDMI connector:

20cm-90-Degree-Down-Angled-Micro-HDMI-Ma

 

You could can strain-relieve such flimsy, flat cables with gaffers tape or paper tape.

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...